Setting Carriage Return-Line Feed; Closing The Link To The Processor; Help; Exiting Telnet (Quit Command - Extron electronics Annotator User Manual

Local echo can be turned off by entering unset local_echo at the Telnet prompt. If
your computer is connected to the Annotator, and you need to access the Telnet
prompt to turn local echo off, enter the Escape sequence (Ctrl + ]).

Setting carriage return-line feed

Unless commanded otherwise, Telnet transmits a line feed character only (no
carriage return) to the connected processor when you press the Enter key. This is
the correct setting for SIS communication with the processor. The Telnet set crlf
command forces Telnet to transmit carriage return and line feed characters when
Enter is pressed; however, if crlf is set, the SIS link with the processor does not
function properly.

Closing the link to the processor

To close the link to the processor, access the Telnet prompt by entering the Escape
sequence (Ctrl + ]). At the Telnet prompt, enter close.

Help

For Telnet command definitions, enter ? at the Telnet prompt.
Exiting Telnet (Quit command)
Exit the Telnet utility by entering quit at the Telnet prompt. If you are connected to
the Annotator, access the Telnet prompt by entering the Escape sequence (Ctrl + ]).
Subnetting — A Primer
A subnet is a subset of a network — a set of IP devices that have portions of their
IP addresses in common. It is not the purpose of this manual to describe TCP/
IP protocol in detail. However, some understanding of TCP/IP subnetting is
necessary in order to understand the interaction of the Annotator and the mail
server gateway. To understand subnetting at the level required to install and
operate the Annotator, you must understand the concepts of a gateway, local and
remote devices, IP addresses and octets, and subnet masks and octets.

Gateways

The Annotator can communicate with the e-mail server that it uses for e-mail
notification directly (if they are on the same subnet), or the communication can be
routed via a gateway (a computer that provides a link between different subnets).
Local and remote devices
The local and remote devices are defined from the point of view of the function
being described. In this manual, subnetting is an issue when you are using the
controlling PC to set TCP/IP values in the Annotator.
IP addresses and octets
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields, properly
called octets, which are separated by dots (periods) (figure B-4). Each octet can be
numbered from 000 through 255. Leading zeros, up to 3 digits total per octet, are
optional. Values of 256 and above are invalid.
Typical IP Address:
Figure B–4 — IP address and octets
192.168.254.254
Octets
Annotator • Ethernet Connection
B-5