Firmware Upgrade; Firmware Rewriting; Upgrade Procedure - Konica Minolta magicolor 7450 Service Manual

5. Firmware upgrade

5. Firmware upgrade
5.1

Firmware rewriting

5.1.1

Upgrade procedure

A. How to upgrade using the Network Interface
1. Connect the machine to the PC using an Ethernet cable.
NOTE
• For connections via a HUB, use a straight cable.
• For direct connections between the printer and PC, use the crossover cable.
• For PCs that support 1000BASE-T (Gigabit Ethernet), use a 1000BASE-T-enabled
Ethernet cable (over category 5e.) If a cable that is not compatible with
1000BASE-T is used, communication may not be made correctly.
• Check that printing is available over the network.
2. From the Menu, select [PRINT MENU] → [CONFIGURATION PG] and execute the
function. Then, check the IP address [1] of the machine.
See P.101
3. Copy the firmware data and upgrading program to any directory on the PC.
4. Start the Command Prompt and go to the directory in which the firmware data is
stored.
5. Execute the following command to start the transfer of the firmware data to the printer.
(The screen shown below indicates that the firmware data resides on the C drive.)
30
Field Service Ver. 1.0 May 2006
[1]
4138F2C003DA
4138F2C004DA