Konica Minolta magicolor 7450 Service Manual page 68

Field Service Ver. 1.0 May 2006
Data to be upgraded
FW upgraded data
XXX.XXX.XXX.XXX : IP address of the machine
****** : File name of FW upgrade data
6. Wait until all of the data is sent.
While the data is being sent, [FIRMWARE UPDATE] and [PROCESSING] are alter-
nately displayed on the screen.
NOTE
• NEVER turn the printer Power Switch OFF and ON while data is being sent.
7. After the data has finished being sent, the message [REBOOTING] appears in the con-
trol panel message display and the printer restarts.
8. After the printer has restarted, check that a [READY] message is displayed.
9. From the Menu, select [PRINT MENU] → [CONFIGURATION PG] and execute the
function. Then, check that the firmware [2] has been upgraded.
See P.101
PRINTER INFORMATION
DATE
TIME
CONTROLLER F/W
ENGINE F/W
BOOT F/W
TOTAL PAGE COUNT
SERIAL NUMBER
B. How to upgrade using the Parallel Interface
1. Connect the machine to the PC using a parallel cable.
NOTE
• Check that printing is available through the parallel cable.
2. Copy the firmware data and upgrading program to any directory on the PC.
3. Start the Command Prompt and go to the directory in which the firmware data is
stored.
4. Execute the following command to start the transfer of the firmware data to the printer.
(The screen shown below indicates that the firmware data resides on the C drive.)
Data to be upgraded
FW upgraded data
******: File name of FW upgrade data
> lpr -S XXX.XXX.XXX.XXX -P lp -o l 4039**********.prn
MM.DD.YYYY
HH.MM
403930G0120000(US)
403950F0150000(US)
403999G0110000
7
******
> copy /b 4039**********.prn prn
5. Firmware upgrade
Command
[2]
Command
4039F2C519DA
4039F2E522DA
31