Configuration Of The As-I Slaves; Configuration Of The As-I Slaves In Step 7 - Siemens SIMATIC ET 200SP Manual

5.3

Configuration of the AS-i slaves

5.3.1

Configuration of the AS-i slaves in STEP 7

During configuration of the AS-i slaves, you specify the stations that the AS-i master is to
communicate with in
Configuration in
● AS-i slaves are displayed graphically in the network view along with their AS-i addresses
(
● The assigned I/O addresses of an AS-i slave are displayed in the Properties window of
the AS-i slave.
● The slave parameters can be configured in the
● The configuration of the slaves is stored in the
documentation easier.
● The configuration data is stored in the PLC and transferred automatically when the
AS-i master is replaced.
● During power-up, the AS-i master switches automatically to "protected operation".
● The diagnostic status of the slave is displayed in
as a symbol (currently only in combination with S7-300 / S7-400 CPU).
Note
If you do not configure any AS-i slaves in
Interface uses the CONFIGURED configuration saved in the AS-i master. The following
sections describe how you can create the CONFIGURED configuration:
• Configuration of the AS-i slaves using the "SET" button (Page 34)
• Configuration of the AS-i slaves via the control panel in the TIA Portal (Page 36)
This does not apply when configuring with a GSD file.
• Configuration of the AS-i slaves using the PLC program (Page 36)
Procedure
You activate configuration of the AS-i slaves in
● In
AS-i network in the network view.
● In
AS-i master (FW V1.1 and higher).
When the AS-i slaves are configured in
"SET" button, via the online function or the PLC program.
This configuration switches the AS-i master automatically to "protected operation".
AS-Interface master CM AS-i Master ST (3RK7137-6SA00-0BC1)
Manual, 07/2017, A5E02655262020A/RS-AD/004
STEP 7
STEP 7
provides the following advantages:
STEP 7
(TIA Portal)) or displayed as a list (
STEP 7
(TIA Portal): by connecting at least one AS-i slave to the AS-i master over an
STEP 7
V5.5: by inserting at least one AS-i slave in the configuration table of the
.
STEP 7
STEP 7
STEP 7
STEP 7
or if you configure using a GSD file, AS-
STEP 7
STEP 7
, configuration is not possible using the
5.3 Configuration of the AS-i slaves
V5.5 and higher).
user interface.
project, which makes
STEP 7
(TIA portal) in the network view
as follows:
Configuring
31