Siemens SIMATIC ET 200SP Manual page 20

Product overview
3.2 Operating modes of the CM AS-i Master ST
Changeover between "configuration mode" and "protected operation"
You can change between "configuration mode" and "protection operation" in one of the
following ways:
● By switching the operating mode using the "Online functions in the TIA Portal (Page 37)".
● By calling the command interface in the user program of SIMATIC with command "No.
0C: Set_Operation_Mode (Page 119)".
● Using the connected "SET" button (Configuration of the AS-i slaves using the "SET"
button (Page 34)).
Changeover is not possible if the AS-i slaves have been configured in the
and the CPU is in RUN operating mode.
20
AS-Interface master CM AS-i Master ST (3RK7137-6SA00-0BC1)
Manual, 07/2017, A5E02655262020A/RS-AD/004
STEP 7
project