Siemens SIMATIC ET 200SP Manual page 164

AS-Interface Protocol Implementation Conformance Statements
A.1 AS-Interface Protocol Implementation Conformance Statement (PICS)
No. Function or command to the host interface (symbolic
representation)
11 Status, Config = Read_Actual_Configuration (Addr)
12 Status = Set_LPS(List31)
13 Status, LPS = Get_LPS()
14 Status, LAS = Get_LAS()
15 Status, LDS = Get_LDS()
16.0 Status = Get_Flags()
16.1 Status, Flag = Get_Flag_Config_OK()
16.2 Status, Flag = Get_Flag_LDS.0()
16.3 Status, Flag = Get_Flag_Auto_Address_Assign()
16.4 Status, Flag = Get_Flag_Auto_Prog_Available()
16.5 Status, Flag = Get_Flag_Configuration_Active()
16.6 Status, Flag = Get_Flag_Normal_Operation_Active()
16.7 Status, Flag = Get_Flag_APF()
16.8 Status, Flag = Get_Flag_Offline_Ready()
16.9 Status, Flag = Get_Flag_Periphery_OK()
17 Status = Set_Operation_Mode(Mode)
18 Status = Set_Offline_Mode(Mode)
19 Status = Activate_Data_Exchange(Mode)
20 Status = Change_Slave_Address (Addr1, Addr2)
21.1 Status = Set_Auto_Address_Enable
21.2 Status = Get_Auto_Address_Enable
22.1 Status, Resp = Cmd_Reset_ASI_Slave (Addr, RESET)
22.2 Status, Resp = Cmd_Read_IO_Configuration (Addr,
CONF)
22.3 Status, Resp = Cmd_Read_Identification_Code(Addr,
IDCOD)
22.4 Status, Resp = Cmd_Read_Status (Addr, STAT)
22.5 Status, Resp = Cmd_Read_Reset_Status (Addr,
STATRES)
22.6 Status, Resp = Cmd_Read_ID−Code_1(Addr, IDCOD1) X
22.7 Status, Resp = Cmd_Read_ID−Code_2(Addr, IDCOD2) X
23 Status, S_List = Get_LPF()
24 Status = Write_ID−Code_11(S_ID−Code_1)
164
M4 Remark / implementation of the function with
X See Section "Description of the AS-i commands
(Page 103)".
X
Access to data record 84.
X
X
X
X
X
X
X
X
X
X
X CP error bit, LED indication (see Section
"Description of the AS-i commands
(Page 103)").
Access to data record 84.
X Access to data record 84.
X
X By pressing the "Configuration mode" or
"Protected operation" button in the control panel
STEP 7
of .
X See section "Description of the AS-i commands
(Page 103)"
- Optional command; not implemented
X See Section "Description of the AS-i commands
(Page 103)".
X
X
-
X
X
X
- Not relevant for AS-i master acc. to profile M4;
not implemented
Not implemented
X See Section "Description of the AS-i commands
(Page 103)".
Access to data record 84.
X See Section "Description of the AS-i commands
(Page 103)".
Not implemented
AS-Interface master CM AS-i Master ST (3RK7137-6SA00-0BC1)
Manual, 07/2017, A5E02655262020A/RS-AD/004