FUTABA 7PX User Manual page 62

Neutral brake "Rate"
Neutral Brake function adjustment
(Preparation)
- Use the switch select function to the "Switch select". (page 69)
When the switch is not set "A switch is not assigned" is dis-
played. Tap [Switch select] to display the switch selection screen
and set the switch.
1
(Neutral brake rate)
Tap the value button of the [Rate]. Value input
buttons appear on the screen and use the
[+] and [-] buttons to adjust the neutral brake
rate amount.
2
When fi nished, return to the Linkage menu screen by pressing the HOME button.
Reference
The ESC neutral brake function and T7PX neutral brake function can be used simulta-
neously. However, when setting is diffi cult to understand, we recommend that only one
neutral brake function be used.
Dial / Trim Setting
When the neutral brake function is
cally assigned to the throttle trim (DT1~DT6 or DL1).
Effect of set value of other functions on neutral brake
Throttle side EPA function, or ATL function setting also affects neutral brake side op-
eration. The Idle-up (page 72) or Engine Cut (page 101) function has priority.
1M23N32602_7PX_E.indb 63
Neutral brake ON/OFF is indi-
cated on the home screen for a
few seconds.
When the neutral brake is ON,
the display of the throttle trim on
the home screen becomes the
neutral brake.
I t i s d i s p l ay e d i n t h e h o m e
screen, when the neutral brake is
ON.
ON , the neutral brake rate adjustment is automati-
" "
Trigger
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Neutral Brake
0~100
Initial value: 0
If the power switch is
turned on while the neu-
tral brake switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
Warning display
63
2017/08/02 14:17:19