FUTABA 7PX User Manual page 25

5
Pass the wiring from the steering wheel unit through the hole in the APA as shown in the
fi gure. Using a Phillips screwdriver fasten the wheel unit and APA at the desired angle using
the 2.6x19 tapping screws.
- Be careful that the screw length is correct. Be careful that the wiring does not get pinched.
- The 2.6x19 tapping screws in the accessory bag
- The angle can be adjusted, but check the marking point on the wheel unit and install the screws.
- Screws can be installed at 4 places, but installation at 4 places may be impossible due to the wheel unit mounting
angle.
Adapter APA
6
Using a Phillips screwdriver fasten the switch unit and APA. Use the 2.6x10mm tapping
screws in the accessories bag. Next, install the APA rear cover. Be careful that the length of
the screws is correct.
- The 2.6x10 tapping screws in the accessory bag
APA rear cover
7
Install the assembled steering wheel unit to the
transmitter body.
- From left to right, the order is 2 pin connector (PS3), 15
pin connector (wheel unit), 4 pin connector (DL1 / PS6).
26
1M23N32602_7PX_E.indb 26
Marking
Wheel unit and APA mounting
screws (2.5x19mm tapping screws)
Switch unit and APA mounting screws
(2.6x10mm tapping screws)
2017/08/02 14:17:05