Mechanical Atl Adjustment; Wheel & Trigger Tension Adjustment - FUTABA 7PX User Manual

Mechanical ATL Adjustment

Make this adjustment when you want to decrease the stroke of the brake (back) side of the
throttle trigger for operation feel.
Adjustment
1
Using a 1.5mm hex wrench, adjust the trigger
brake (reverse) stroke. (The screw moves the
throttle trigger stopper.)
• When the screw is turned clockwise, the stroke becomes
narrower. Adjust the stroke while watching the screw.
Note:
Once you have changed the mechanical stroke on the brake side, be sure to adjust the
scale of the throttle channel accordingly by using the " Calibration Function " (page 184).
Due to this change, you also need to adjust in most cases the travel of the throttle servo
by using " Data Setting. "
Wheel & Trigger Tension Adjustment
Make this adjustment when you want to change the wheel or trigger spring's tension.
Adjustment
1
Using a 1.5mm hex wrench, adjust the wheel
spring tension by turning the screw inside the
adjusting hole.
- The spring is set to the weakest tension at the factory.
- When the adjusting screw is turned clockwise, the spring
tension increases.
Note:
The adjustment range is up to 7 to 8 turns from the fully tightened (strongest) position. If
turned farther than this, the adjusting screw may fall out.
22
1M23N32602_7PX_E.indb 22
Wheel tension
adjusting screw
Mechanical ATL
adjusting screw
Trigger tension
adjusting screw
2017/08/02 14:17:01