Response Mode/ Sr Check - FUTABA 7PX User Manual

Response Mode/ SR Check

Make sure that the response mode or SR mode setting matches the servo or other equipment
to be used.
T-FHSS
If the setting is incorrect, change it by the following method.
How to set the response / SR mode
1
From the Home screen, press the HOME button or tapped [Menu] on the touch panel. Next,
select [Receiver] at the Linkage menu and access the setup screen shown below by tapping
the screen.
HOME
2
For the T-FHSS / S-FHSS / FASST system, touch [Digital Servo] or [Analog Servo] in the
receiver setting and make changes. The display changes when mode is changed.
When the power of the receiver is turned on, be sure to turn the power off and then on
again.
40
1M23N32602_7PX_E.indb 40
Response mode is displayed.
"Digital servo"
"Analog servo"
Menu
From an analog servo
to a digital servo
From a digital servo to
an analog servo
Receiver
Display ON / OFF of SR mode.
In the case of the channel indicated
as [SR], SR mode is ON. If it is not
displayed, SR mode is OFF.
For SR mode, ON / OFF can be set
for each channel.
T-FHSS SR
Linkage menu Receiver
Changes to a
digital servo
Changes to an
analog servo
2017/08/02 14:17:11