Calibration - FUTABA 7PX User Manual

Steering and throttle correction can be applied. Use this function when a mechanical offset
has occurred for some reason.
However, if correction was applied, it may be necessary to recheck the set values of all
the setup functions.
Home screen
Steering adjustment
(Preparation)
Tap the [Wheel]. The neutral correction screen appears.
1
(Steering neutral adjustment)
After the wheel lightly to the left or right, tap the [Neutral] in
the state in which the wheel is not touched. If neutral correc-
tion is OK, the end point correction screen appears. If not
within the correction range, the end point correction screen
will not appear.
2
(Steering wheel travel adjustment)
In the end point correction screen (figure at the right) state,
lightly turn the wheel fully to the left and right and tap the [End
point]. If end point correction is OK, the display returns to the
adjuster screen. If the end point is not within the correction
range, the display does not return to the adjuster screen. In
this case, return to the system menu screen by pressing the
HOME button. If operation cannot be ended normally even
when correction is repeated, please contact the Futaba Ser-
vice Center.
3
When finished, return to the System menu screen by pressing the HOME button.
184
1M23N32602_7PX_E.indb 184

Calibration

Menu screen System menu screen
Calibration
Calibration
2017/08/02 14:17:48