Trigger Ratio Check; Trims Initial Set-Up - FUTABA 7PX User Manual

Trigger Ratio Check

-The throttle servo travel can be set to 50:50, 70:30 or 100:0 for throttle trigger operation as
required by the Trigger function (page 62).
-The throttle brake operation might be close by setting it to "100:0" when the T7PX trans-
mitter with the boat is used.
Trigger

Trims Initial Set-Up

- Steering trim (DT1) check
On the initial set-up, steering trim is assigned to the DT1 trim lever above. Operate the lever
and make sure the marker moves on the ST graph. If default has been changed, test steering
trim in its new location. After checking the trim, set the trim display to the center (N) posi-
tion.
- Throttle trim (DT2) check
On the initial set-up, throttle trim is assigned to the DT2 trim lever. Operate the lever and
make sure the marker moves on the TH graph. If the default has been changed, test the
throttle trim in its new location. After checking the trim, set the trim display to the center (N)
position.
Throttle trim (DT2)
42
1M23N32602_7PX_E.indb 42
Forward 50: Brake 50
Forward 70: Brake 30
Forward 100: Brake 0
50 : 50
Forward 50: Brake 50
Steering trim (DT1)
70 : 30
Forward 70: Brake 30
Forward 100: Brake 0
Steering trim
Throttle trim
100 : 0
2017/08/02 14:17:12