Table of Contents
Advertisement
Backup Error
System Error
*Protect the screen from scratches and dirt.
*It's a little smaller than the T7PX screen size, so that is easier attach
and stick tight.
*The protector has a front and back backing.
How to attach the protector
1
Clean your screen using a glass cleaner with a lint-
free microfiber cloth. Wipe off the dust from the screen
t h o r o u g h l y b e f o r e a p p l y i n g t h e s c r e e n p r o t e c t o r.
(Dust and dirt are the reasons for air bubbles underneath the
protector.)
2
Remove one side of the plastic backing. Along one edge about
one inch and fold down the backing to expose the protector.
Be careful not to touch the screen protector. Align the screen
protector along the edge of the screen. Be sure to attach the
exposed one inch of the protector film straight to the screen.
Press the clean screen protector gently and steadily, press on
the screen surface as you peel the backing away. Or gently
slide a credit card over the surface, use as a squeegee to get
as many of the air bubbles out for you. Slowly press out any
air bubbles.
3
After attaching the protector is done. Remove the front backing.
190
1M23N32602_7PX_E.indb
190
If the data in the transmitter is not transferred normally when the power is turned
on, an audible alarm will sound and "Backup error" will be displayed on the LCD.
Audible alarm: Continuous tone.
- To stop the alarm, turn off the power.
- Turn the power back on. If the alarm is not generated
again, there is no problem.
If the data is lost for an unknown reason, an audible alarm will sound and "System
error" will be displayed on the LCD screen.
Audible alarm: Continuous tone.
Warning
When a system error is generated, immediately stop using
the system and request repair from the Futaba Service Center.
If you continue to use the system, the transmitter may malfunction and cause
loss of control.
T7PX Screen Protector
Front backing
Screen protector
Back backing
2017/08/02
14:17:50
Advertisement
Table of Contents
