Sensor Reload - FUTABA 7PX User Manual

When using multiple sensors of the same type the sensors must be registered in the trans-
mitter. Connect all the sensors to be used to the T7PX as shown in the fi gure at the right
and register them by the following procedure. The ID of each sensor is registered in the
transmitter.
To load the sensor, connect all sensors to be used to the T7PX communication port as
shown below. Power supply is unnecessary. Also, to clear all sensor registration, execute
this [Reload] function without connecting sensor. The registration is cleared and all the
slots in the sensor list are unregistered.
How to change start slot and set empty slot
1
(Start slot selection)
Tap the [Reload], The confi rmation screen will be displayed. To execute, tap [Yes] to hear an
electronic sound and fi nish setting. To cancel, select [No] and touch it. If "Success" appears
on the screen, reload is complete.
2
When fi nished, return to the Telemetry screen by pressing the HOME button.
1M23N32602_7PX_E.indb 165

Sensor Reload

Communication port.
Cover
Sensor
All the sensors to be used
a r e c o n n e c t e d t o t h e
T7PX.
Sensor
Sensor
Sensor
2017/08/02
165
14:17:44