Access Control - Canon Oce PlotWave 300 Administration Manual

Access control

Introduction
The 'Access control' feature is available on the following printers and versions:
- Océ ColorWave 550 v2.3.1 and higher
- Océ ColorWave 650 v2.3.1 and higher
- Océ ColorWave 650 PP v2.3.1 and higher
Use the access restriction to limit the access to the printer
Enable 'Access control' and set the list of IP addresses of the computers (hosts) that will be able
to communicate with the printer controller, for printing only.
Once enabled, you can define up to 5 hosts.
In case you use a print server, this server must be declared in the list of hosts to be able to print
from this server.
For each of the hosts you can decide whether the communication from this host to the system
needs to be encrypted by IPsec (see
You can enable 'Access control' in Océ Express WebTools. You can disable it in Océ Express
WebTools or via the printer user panel.
NOTE
- In case DHCP and DNS servers are used:
• Add the DHCP server in the list of the Access control stations.
Otherwise the DHCP protocol is disabled: you can disable the DHCP settings in the
Configuration - Connectivity settings and configure the network settings manually.
• Add the DNS server in the list of the Access control stations.
Otherwise the DNS protocol is disabled: you can configure the path of the external locations
with the IP address instead of a hostname.
- 'Configuration' of the 'Access control' settings is only available to the 'System administrator'.
- To prevent unauthorised access to these settings via the printer user panel, ensure that the
'Password to change network settings' is set.
IPsec for Océ ColorWave printers on page
Chapter 5 - Security on Océ ColorWave 550/600/650 (and Poster Printer)
Access control
253)
249