Canon Oce PlotWave 300 Administration Manual page 286

Configure the IPsec settings on a workstation or a print server
3. In the 'Access control' section, click on the general 'Edit'
4. Check the 'Enable/Disable IPsec' box to enable 'IPsec'
You can also activate the Access control
5. Enable 'IPsec control station 1'
Tip: When you enable Access control, it is recommended to declare the workstation from which
you remotely configure the system, at least during the configuration time (IPsec not needed).
6. Enter the IPsec preshared key or keep it empty to use the default preshared key . You can
configure the default preshared key at the bottom of the Network security section.
• 256 characters maximum
• Any MS character
NOTE
Write down this preshared key. It will be required during the IPsec configuration on the
workstation.
7. Click OK
Note: The settings are applied as soon as 'OK' is validated (and before the restart). You may lose
the remote connection to the system when your workstation is not part of the configured stations.
8. Restart the controller
Result
The IPsec settings are configured on the controller for a connection to a workstation.
Configure the IPsec settings on a workstation or a print server
When to do
After the IPsec configuration on the controller.
Pre-requisites
Log on the workstation with the Administration rights.
286 Chapter 5 - Security on Océ ColorWave 550/600/650 (and Poster Printer)