Canon Oce PlotWave 300 Administration Manual page 30

Set the security level in Océ PlotWave 900 R1.1 and higher R1.x versions
Result
You must type the password in the printer user panel when you want change the security level.
Set the security level in Océ PlotWave 900 R1.1 and higher R1.x versions
Introduction
The security user interface is available through the Océ Express WebTools application.
NOTE
You need to be logged on as the System Administrator to access the security level interface and
change the security levels.
Procedure
1. Open the Océ Express Webtools in a web browser (http://Printer IP address or hostname)
2. On the [Configuration] tab, select [Connectivity]
3. Go to the Security section
4. Click on 'Edit' or double click on the value to open the [Security level] window
5. Set the security level and click 'OK'
6. Restart the printer when prompted
Result
After you set the Security level to 'High', you must open Océ Express Web Tools by means of the
HTTPS protocol: type https://Printer IP address or hostname in the web browser.
30 Chapter 2 - Security on Océ PlotWave 300/350, PlotWave 750, PlotWave 900 and ColorWave 300