Installing The Isolator Lead (Option); Installing The Gauge Harness - Yamaha F150B Service Manual

RIG
GING
5. Adjust the cable joint a to the pin c of
the throttle cam.
throttle cable joint must be screwed in
a minimum 8.0 mm (0.31 in).
a
Dimension d: 8.0 mm (0.31 in)
6. If the cable joint is not maintained the
engagement of
(0.31 in) d, remove the bolts f and
remount the holder with the holes e or
f.
f
f
7. Install the cable joint a to the pin c, and
secure it with the clip g.
TIP:
Pull the inner cable to avoid the free play
(backlash) of the cable, and install it to the
pin.
8. Tighten the locknut h to the specified
torque.
3-11
Rigging information
WARNING! The
c
d a
minimum 8.0 mm
e
g
c
Locknut h: 5 N·m (0.5 kgf·m, 3.7 ft·lb)
9. Check the throttle cable for proper
operation.

Installing the isolator lead (option)

Carry out the following procedures only when
the isolator lead (option) is used.
1. Remove the cap a from the isolator cou-
pler.
a
2. Connect the isolator lead b it's coupler.
b

Installing the gauge harness

See "Rigging guide" for the installation of the
gauge to the boat.
1. Remove the coupler a from the bracket
a.
a
h