Removing The Wiring Harness - Yamaha F150B Service Manual

Removing the wiring harness

1. Remove the flywheel magnet cover.
2. Remove the flywheel magnet. See
"Removing the flywheel magnet" (7-6).
3. Disconnect the PTT switch coupler a,
trim sensor coupler b, and water
detection switch coupler c.
4. Remove the gauge harness coupler d
from the bracket.
c
b
5. Disconnect the shift cut switch coupler e
and neutral switch coupler f.
e
f
6. Disconnect the all fuel injector couplers.
7. Disconnect the fuel pump coupler g.
8. Remove the projection h of the plastic
tie from the fuel rail a.
g
a
9. Disconnect the TPS coupler k, ISC
coupler m, air pressure sensor coupler
n, and engine temperature sensor
coupler p, and then remove the wiring
harness from the brackets b.
d
10. Disconnect the hour meter coupler r.
a
r
11. Remove the cover c.
c
12. Disconnect the engine ECM coupler s
and pulser coil coupler t, and then
remove the engine ECM d.
h
Wiring harness
m
n
k
d
s
0
1
b
2
p
3
4
5
6
7
8
9
10
t
A
7-8