Yamaha F150B Service Manual page 86

RIG
GING
2. Remove the bolts c, and then remove
the retaining plate b.
b
3. Fully screw in the cable joint d to the
shift cable e.
e
4. Set the remote control lever in the N
position.
5. Open the clamp g of the shift cable
holder f.
f
TIP:
Shift cable position is adjustable by using the
shift cable holder f.
6. Pass the shift cable e through the
rigging grommet, fit the cable groove
onto the projection on the cable holder f
for installation.
3-9
Rigging information
c
d
g
e
f
7. Align the mark a on the bushing h with
the mark b on the plate i.
h
8. Adjust the cable joint d to the pin c of
shift lever. WARNING! The shift cable
joint must be screwed in a minimum
of 8.0 mm (0.31 in).
c
Dimension d: 8.0 mm (0.31 in)
9. If the cable joint is not maintained the
engagement of
(0.31 in) d, remove the bolt j and
remount the holder with the hole e or f.
e
a
i
b
d
d d
minimum 8.0 mm