Installing The Shift Rod - Yamaha F150B Service Manual

LOWR
4. Install the original shim(s) (T2) g, the
propeller shaft housing assembly e, and
key h.
TIP:
Do not reuse a shim if it is any deformed or
scratched.
5. Install the claw washer. Check that the
positions a is set in place properly.
a
6. Install the ring nut, and then tighten the
ring nut to the specified torque.
j
i
Ring nut wrench 4 i: 90890-06512
Ring nut wrench extension j:
90890-06513
Ring nut:
143 N·m (14.3 kgf·m, 105.5 ft·lb)
8-21
Lower unit
e
h
g
7. Bend one claw toward the propeller and
the other 3 claws toward the gear.

Installing the shift rod

1. Make sure that the gear shift is in the N
position, and then install the shift rod
assembly a.
2. Make sure that the drive shaft and the
propeller shaft are moving properly when
the gear is shifted into F position and into
R position.
a