Bleeding The Ptt Unit; Installing The Ptt Unit - Yamaha F150B Service Manual

Ram PTT motor lead
Black/White (B/W)
Up
Black (B)
13. Remove the special service tools, and
then install the manual valve and circlip.
Manual valve:
3.5 N·m (0.35 kgf·m, 2.58 ft·lb)
TIP:
Quickly install the manual valve before any
fluid flows out of the hole.
14. For checking the fluid level, proceed the
step 2–step 4 again.

Bleeding the PTT unit

1. Place the PTT unit in an upright position.
2. Close the manual valve a by turning it
clockwise.
a
Manual valve a:
3.5 N·m (0.35 kgf·m, 2.58 ft·lb)
3. For checking the
"Checking the hydraulic pressure" (9-34)
step 2–step 4.
4. Connect the PTT motor leads to the
battery terminals to fully retract the PTT
rams.
Battery
terminal
+
–
fluid level, see
5. Reverse the PTT motor leads between
the battery terminals to fully extend the
PTT rams.
B
B/W
B/W B
Ram PTT motor lead
Black (B)
Down
Black/White (B/W)
Black/White (B/W)
Up
Black (B)
TIP:
If the PTT rams do not move up and down
easily, push and pull the PTT rams to assist
operation.
6. Check the fluid level when the PTT rams
are fully extended. If the fluid level is low,
add sufficient fluid, and then repeat step
3–step 7.

Installing the PTT unit

• After tilting the swivel bracket up, make
sure to support it with the tilt stop lever.
• When installing the PTT unit with the
power unit installed, make sure to sus-
pend the outboard motor. If the outboard
motor is not suspended it can fall sud-
denly and result in severe injury.
PTT unit
0
1
2
3
4
Battery
5
terminal
+
–
6
+
–
7
8
9
10
A
9-36