Yamaha F150B Service Manual page 402

BRKT
1. Connect the PTT motor leads a to the
battery terminals to retract the PTT rams.
B B/W
Ram PTT motor lead
Black (B)
Down
Black/White (B/W)
2. Fully tilt the swivel bracket up, and then
support it with the tilt stop lever a.
a
3. Install the bushings b.
4. Install the bushings c to the tilt ram end
and swivel bracket.
5. Install the PTT unit d, and then install
the shaft e.
6. Tighten the shaft bolts f to the specified
torque.
9-37
Bracket unit
Battery
terminal
+
–
e
f
Bolt f:
39 N·m (3.9 kgf·m, 28.7 ft·lb)
7. Pass the PTT motor leads a through the
hole b in the clamp bracket (PORT).
8. Connect the PTT motor leads a to the
battery terminals to extend the PTT
rams.
b
a
B/W
Ram PTT motor lead
Black/White (B/W)
Up
Black (B)
c
f
c
b
a
B
Battery
terminal
+
–
d
b