Disassembling The Upper Case; Checking The Drive Shaft Bushing; Assembling The Upper Case - Yamaha F150B Service Manual

BRKT

Disassembling the upper case

1. Remove the drain bolt a.
a
2. Remove the upper case bolts b and c,
and then remove the oil pan assembly
d.
c
b
d
3. Remove the circlip e, and then remove
the bushing f.
e
h
f
Bearing puller assembly g: 90890-06535
Stopper guide stand h: 90890-06538
Stopper guide plate i: 90890-06501
9-17
Bracket unit
c c
b
i
g
h

Checking the drive shaft bushing

1. Check the bushing. Replace if cracked or
worn.

Assembling the upper case

1. Install the bushing a, and then install the
circlip b.
a
b
c
Needle bearing attachment c:
90890-06653
Driver rod L3 d: 90890-06652
2. Install the dowels e.
3. Install the baffle plate f, and then
tighten baffle plate screws g to the spec-
ified torque.
4. Install the rubber seal h into the joint
hole a of the upper case.
5. Install a new rubber seal i and the rub-
ber seal j, and then install the oil pan
assembly k.
TIP:
Make sure to insert the tip of the cooling
water pipe l into the joint hole a of the
upper case.
6. Install the oil pan bolts m and n, and
then tighten them to the specified
torques.
d
c
a