Configure Ip Settings; Configure The Routing Settings - NETGEAR ProSafe XS728T User Manual

ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual

Configure IP Settings

From the Routing > IP menu, you can access pages that are described in the following
sections:
•

Configure the Routing Settings

• View the IP Statistics
Configure the Routing Settings
Use the IP Configuration page to configure routing settings for the switch.

To enable routing on the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing > IP > IP Configuration.
6. Select the Routing Mode Enable radio button.
You must enable routing for the switch before you can route through any of the interfaces.
Routing is also enabled or disabled per VLAN interface. The default value is Disable.
7. In the IPv4 MTU field, enter the maximum transmission unit (MTU) for IPv4 packets.
The MTU for IPv4 packets can range from 576 to 9000. The default is 1500.
8. Click the Apply button.
on page 164
on page 165
Configure Routing
164
Change the Default IP Address of the