1.4
How to Select and Set a Display
There are two base screens; plotter and echo sounder. You can display combination
data with these two modes. See chapter 2 for plotter, chapter 11 for echo sounder.
1.4.1
How to select a display
Press the DISP key consecutively to cycle through all the active displays. Displays
other than display 1 can be skipped. See section 1.4.3.
1.4.2
How to change a display's setting
Five basic screens are pre-prepared. You can change the configuration of each
screen to meet your operational needs, as shown in the procedure below. For menu
operation, see section 1.5.
1. Press the MENU key to open the main menu.
2. Select [0. SYSTEM SETTING].
3. Select [4. DISPLAY SETTING].
1. OPERATIONAL OVERVIEW
1-5