Furuno GP-3700F Operator's Manual page 127

4. Select [1. PORT 1 SETTING], [3. PORT 2 SETTING] or [5. PORT 3 SETTING].
5. Select an item to change.
[CONNECTED DEVICE]: Selects the device connected to the port 1 (or 2, 3) from
[NORMAL], [RADIO EQUIPMENT], [AIS], [GPS BUOY], [AUTO PILOT] or [RT-
CM].
[FORMAT]: Selects [NMEA0183 ver1.5], [NMEA0183 ver2.0], [NMEA0183
ver3.0] or [NMEA0183 ver4.1] depending on the navigator connected.
[BAUD RATE]: Selects the baud rate (bps) from [4800] or [38400].
[TLL OUTPUT]: Select [ON] to output L/L data, at the moment a mark is entered,
to the navigator connected.
[LAT/LON FORMAT]: Selects the number of minute places to shown in latitude
and longitude position, from hundredth, thousandth or ten thousandth.
[OUTPUT WAYPOINT]: Select [ON] to output the WPL and RTE sentences to the
navigator connected when setting a route as destination.
Note: The RTE sentence is not output for the route which has only one waypoint
(quick point).
[OUTPUT CONSORT INFO.]: Select [ON] to output the consort data to the navi-
gator connected.
[OUTPUT RADIO MESSAGE]: Select [ON] to output the radio message to the
navigator connected.
[DATUM SELECTION]: Selects the datum for the external equipment connected
from [WGS-84] or [TOKYO].
6. Select an option.
7. Press the MENU key to return to the [5. INPUT/OUTPUT PORT SETTING] menu.
9. OTHER FUNCTIONS
9-19