How To Enter Waypoints By Range And Bearing - Furuno GP-3700F Operator's Manual

5. WAYPOINTS
12. Set the waypoint name (see "How to enter alphanumeric data" on page 1-10).
13. Select [MARK COLOR].
14. Select the mark color.
15. Select [MARK SHAPE].
16. Select the mark shape.
17. Select [MARK DISPLAY].
18. Select [YES] or [NO].
[YES]: Shows the waypoint mark on the plotter display.
[NO]: Hides the waypoint mark on the plotter display. Waypoint marks selected to
[NO] are grayed out in [WAYPOINTS LIST].
19. Select [INT. BAN].
20. Press the numeric keys to enter the intrusion ban alarm radius.
[INT. BAN] is the alarm range that will be used for this waypoint when the intrusion
point alarm is active. When the intrusion ban alarm radius is other than 0.00 NM,
the waypoint marks on the plotter display and the waypoint list become
matically. For how to set the intrusion point alarm, see section 8.5.
21. Select [COMMENT].
22. Enter the comment (see "How to enter alphanumeric data" on page 1-10).
23. Select [RUN] to close the [EDIT WPT NAME] window.
24. Press the DISP key to close the menu.
5.1.4

How to enter waypoints by range and bearing

This method is useful when you want to enter a waypoint by using range and bearing
to a target found on the radar display.
1. Press the MENU key to open the main menu.
2. Select [1. ROUTES/WAYPOINTS LIST].
3. Select [1. WAYPOINTS LIST].
4. Press the WPT key or ENTER knob to show the [EDIT WPT NAME] window.
Note: Push the ENTER knob after selecting a blank line.
5. Select [COORDINATE].
5-4
auto-