Figure 23: Connecting Ac Power To The Router - Juniper ACX1000 Hardware Manual

ACX1000 and ACX1100 Universal Access Router Hardware Guide
Related
Documentation
94
Insert the power cord plug into an external AC power source receptacle.
4.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated customer site circuit breaker. We recommend that
you use a dedicated customer site circuit breaker rated for 2 A (100 VAC)
or 1 A (240 VAC), or as required by local code.
Dress the power cord appropriately. Verify that the power cord does not block the air
5.
exhaust and access to router components, or drape where people could trip on it.
Repeat Step 1 through Step
6.
Observe the system LED on the router. If an AC power supply is functioning normally,
7.
the system LED lights green steadily.
If the system LED is not lit, the power supply is not functioning normally. Repeat the
cabling procedures.

Figure 23: Connecting AC Power to the Router

ACX1100 AC Power Specifications on page 61
5 for the remaining power supply.
Copyright © 2017, Juniper Networks, Inc.