Connecting An Acx1000 Or Acx1100 Fiber-Optic Cable - Juniper ACX1000 Hardware Manual

ACX1000 and ACX1100 Universal Access Router Hardware Guide

Connecting an ACX1000 or ACX1100 Fiber-Optic Cable

116
To disconnect a fiber-optic cable from an optical transceiver installed in the router:
Disable the port in which the transceiver is installed by issuing the command:
1.
[edit interfaces]
user@router# set interface-name disable
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
Carefully unplug the fiber-optic cable connector from the transceiver.
2.
Cover the transceiver with a rubber safety cap.
3.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
Cover the fiber-optic cable connector with the rubber safety cap.
4.
ACX Series routers have field-replaceable unit (FRU) optical transceivers to which you
can connect fiber-optic cables.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in a
router, ensure that you have taken the necessary precautions for safe handling of lasers
(see "Laser and LED Safety Guidelines and Warnings" on page
To connect a fiber-optic cable to an optical transceiver installed in an ACX Series router:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
158).
Figure 30 on page 117).
Copyright © 2017, Juniper Networks, Inc.