Installing An Acx1000 Or Acx1100 Transceiver - Juniper ACX1000 Hardware Manual

See Also

Installing an ACX1000 or ACX1100 Transceiver

Copyright © 2017, Juniper Networks, Inc.
Place a rubber safety cap over the transceiver.
8.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
9.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
Front Panel of an ACX1000 Router on page 30
Uplink Ports on ACX1000 and ACX1100 Routers on page 32
Installing an ACX1000 or ACX1100 Transceiver on page 101
To install a transceiver:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
Chapter 22: Replacing Chassis Components
119