Ele To Camber - FUTABA 14SG Instruction Manual

ELE to CAMBER

This function is used when you want to mix the
the flaps are lowered by up elevator, and lift is
increased.
and access the setup screen shown below
by touching the RTN button.
and return to the Model
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
RETURN
Setting method
the RTN button to switch to the data input
touch sensor.
*The display blinks.
Touch the RTN button to activate the
When setting a switch, move the cursor to
call the selection screen. Select the switch
(Glider: Currently selected condition name)
<SensorTouch™>
*The display screen is an example.
The actual screen depends on the
model type.
Move the cursor to the up or down mixing
rate item for each servo and touch the RTN
button to switch to the data input mode.
the touch sensor.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
*For a description of the switch selection method, see the
description at the back of this manual.
hold the elevator stick to the desired position
button for one second to set the range.
*The mixing does not work near neutral of the elevator stick.
<Model Menu (Airplane/Glider Functions)>
Scrolling
129