Elevator Compensation Curve Adjustment; Servo Speed Setting - FUTABA 14SG Instruction Manual

Setting method
the RTN button to switch to the data input
touch sensor.
*The display blinks.
Touch the RTN button to activate the
When setting a switch, move the cursor to
call the selection screen. Select the switch
*For a description of the switch selection method, see the
description at the back of this manual.
Move the cursor to the aileron, flap or
elevator rate item and touch the RTN button
rate independently by scrolling the touch
sensor.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
FLP 3
(Brake Flap)
FLP 1
(Camber Flap)
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
V-TAIL
ELEVATOR
ELEVATOR 2
132 <Model Menu (Airplane/Glider Functions)>
FLP 4
(Brake Flap)
FLP 2
(Camber Flap)
AIL 2
(Main Aileron)
AIL 4
(Chip Aileron)
AILVATOR
ELEVATOR
ELEVATOR 2
Offset point
Settable
Settable
* The range where mixing does not work close to the neutral
position of the elevator stick can be adjusted. (Glider only)
*When offset is set, the curve is initialized.
hold the airbrake stick to the desired position
and then touch the RTN button for one
second to set the butterfly operational
reference point.
Move the cursor to the aileron, flap or
elevator speed item and touch the RTN
button to switch to the data input mode.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to activate the
function and return to the cursor mode.
Settable