Ele → Camber - FUTABA T18SZ Instruction Manual

Ele → Camber
This function is used when you want to mix the
camber flaps with elevator operation. When used,
the flaps are lowered by up elevator, and lift can
be increased.
● Select [Ele→Camber] at the model menu
and call the setup screen shown below.
●Return to Model menu
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Ailerons and flaps rate
adjustment
Activate the function by
tapping the [INH] .
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Setting method
● Tap to the [INH] item.
(ON is displayed.)
● When setting a switch, tap to the [--] item
of the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
132
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]: Airplane/glider, 2 ailerons or more
Note: Tailless wing elevator can be operated
when this mix is activated.
● A mixing curve can be set.
● Mixing during flight can be turned ON/OFF by
● The mixing rate can be fine-tuned by setting a VR.
Currently selected condition name
● When setting a VR, tap to the Fine tuning
T h e V R o p e r a t i o n m o d e c a n a l s o b e
● A mixing curve can also be set.
(For a description of the curve setting
setting a switch. (Always ON at [--] setting)
"--" item and tap the screen to call the
selection screen, and then select the VR. The
adjustment rate can be set.
selected.
method, see the description at the back of
this manual.)
Overall adjustment by
Rate A and Rate B.
The value inside the
parentheses shows the
current rudder position.
Fine tuning VR setting
Operation mode
Adjustment rate