Ailevator; Travel Adjustment (Ailevator) - FUTABA 14SG Instruction Manual

AILEVATOR

This function improves the performance of the roll
axis by operating the elevators as ailerons.
Ailevator is where each elevator in a standard
(conventional) or v-tail moves independently, like
ailerons on a wing. In addition to each elevator side
moving up and down together, each side moves in
opposite directions when moving as an Ailevator. On
a V-tail, this is also known as a Ruddervator, as they
can serve the same purpose. Typically, both Ailevator
and ailerons are coupled together to maximize roll
performance, especially on larger wingspan planes.
and access the setup screen shown
below by touching the RTN button.
and return to the Model
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
RETURN
elevators when the elevator stick
i s m o v e d c a n b e i n d i v i d u a l l y
Setting method
Move the cursor to the item you want to
the data input mode.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
140 <Model Menu (Airplane/Glider Functions)>
(Effective only when 2 servos used at the elevators)
ELEVATOR
(AILERON 5)
<SensorTouch™>
as ailerons, aileron travel of
the left and right elevators
*If the mixing direction is reversed, adjustments can be made
by changing the mixing rate polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out of
travel. Decrease the travel until no binding occurs.
ELEVATOR 2
(AILERON 6)
Scrolling