Rud To Ail - FUTABA 14SG Instruction Manual

RUD to AIL

This function is used when you want to mix
the ailerons with rudder input. It is used when
rudder is applied during roll maneuvers such
as, knife edge flight. It can be used to turn or
bank scale models, large models, etc. like a full-
size aircraft.
menu and access the setup screen
shown below by touching the RTN
button.
and return to the Model
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
RETURN
Setting method
the RTN button to switch to the data input
touch sensor.
*The display blinks.
Touch the RTN button to activate the
When setting a switch, move the cursor to
call the selection screen. Select the switch
*For a description of the switch selection method, see the
description at the back of this manual.
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 1
Winglet
( )
at Flying wing
V-TAIL
RUDDER 2
(Glider: Currently selected condition name)
<SensorTouch™>
*The display screen is an example.
Move the cursor to the left or right item
and touch the RTN button to switch to the
independently by scrolling the touch sensor.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
and return to the cursor mode.
To activate the link mixing, move the cursor
to switch to the data input mode. Select the
ON mode by scrolling the touch sensor.
*The display blinks.
Touch the RTN button to set the link mode
and return to the cursor mode.
<Model Menu (Airplane/Glider Functions)>
AIL 2
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 2
Winglet
(
at Flying wing
RUDDER
RUDDER
Scrolling
The actual screen depends on the
model type.
125
)