Gyro Function - FUTABA 14SG Instruction Manual

GYRO
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/
AVCS mode) can be changed via a switch.
switched.
simultaneously controlled.
access the setup screen shown below
by touching the RTN button.
and return to the Model
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
RETURN
screen selection
selection
Setting method
*Prior to using the Function menu in the Linkage menu to
assign the sensitivity channel (Gyro/Gyro2/Gyro3) select an
unused channel.
Set [Control] and [Trim] other than function to [--].
Move the cursor to the setup screen selection
item and touch the RTN button to switch
to the data input mode. Select the setup
screen # by scrolling the touch sensor.
Note: This setting does not assign a sensitivity
channel. To do so, use the Linkage menu
prior to assigning the sensitivity channel
(Gyro/Gyro2/Gyro3), be sure to select an
unused channel.
Set the [Control] and [Trim] settings other than
Function to [--].
(Active rate # display)
<SensorTouch™>
and sensitivity of the three axis
Touch the RTN button to change the setup
screen and return to the cursor mode.
the RTN button to switch to the data input
touch sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
<Model Menu (Airplane/Glider Functions)>
Scrolling
137