Pit Curve; Vpp Condition Selection - FUTABA 14SG Instruction Manual

PIT CURVE

This function adjusts the pitch curve for VPP
(Variable Pitch Propeller) airplane.
*Up to 3 conditions can be set.
and access the setup screen shown
below by touching the RTN button.
and return to the Model
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
RETURN
Setting method
1. Move the cursor to the # button at the top
right side of the screen and touch the RTN
button to switch to the data input mode.
touch sensor.
*The display blinks.
Touch the RTN button to call the setting
screen and return to the cursor mode.
2. Move the cursor to the switch item and
touch the RTN button to access the selection
screen. Select the switch and set its ON
direction.
*For a description of the switch selection method, see the
description at the back of this manual.
*The VPP conditions can also be checked in the HOME
screen.
1. Move the cursor to the curve rate setting
N O T E : W h e n V P P i s n o t a s s i g n e d t o a n y
channel, the pitch curve is not displayed in
the model menu. In this case, assign VPP to
any channel on the function screen.
<SensorTouch™>
button to switch to the data input mode.
*When the RTN button is touched for one second, the rate is
reset to the initial value.
and return to the cursor mode.
2. Repeat this procedure for each point.
1. Move the cursor to the curve point setting
button to switch to the data input mode.
sensor.
*When the RTN button is touched for one second, the curve
position is reset to the initial value.)
and return to the cursor mode.
2. Repeat this procedure for each point.
Move the cursor to the curve point setting
the RTN button for one second.
<Model Menu (Airplane/Glider Functions)>
Scrolling
117