Akai MPC 4000 Reference Manual page 225

Program mode
LFO1 block
Here you can adjust the LFO1 parameters.
A Wave field
Selects one of the following waveforms for LFO1.
B Selected waveform field
Displays the selected waveform. The display will change according to the parameter settings.
C Depth field
Adjusts the LFO1 output level in a range of 0–100. Increasing this value will produce a
more intense effect.
Note: In order to use the LFO, the modulation source, modulation destination, and modulation depth
must be specified in the Program Modulation popup window.
Be aware that simply raising the value of the Depth field is not enough to produce an effect.
D Rate field
Adjusts the LFO1 frequency in a range of 0–100. Increasing this value will produce faster
modulation.
E Delay field
Adjusts the time from when note-on is received until the LFO1 effect is applied, in a
range of 0–100. Increasing this value will produce a longer delay from note-on until the
effect is applied.
F Phase field
Adjusts the location at which the LFO1 cycle will start. The vertical dotted line in the
waveform display field will move according to this setting.
G Shift field
Shifts the LFO1 level upward or downward. The horizontal line in the waveform display
field will move according to this setting.
H Sync field
Selects whether the LFO1 of all voices in this program will be synchronized. If this set-
ting is off, the effect applied to each voice will cycle independently.
I MIDI sync field
Specifies whether the LFO1 rate will be synchronized to MIDI clock messages received
from an external device. If this setting is on, the LFO1 rate will synchronize to the
received MIDI clock.
216
1
3
4
5
TRIANGLE (Triangle wave)
SAW UP
(Upward sawtooth wave) (Downward sawtooth wave)
2 6 9
7 8 J K
SINE (Sine wave) SQUARE (Square wave)
SAW DOWN RANDOM (Random)