Akai MPC 4000 Reference Manual page 153

Effect mode
DISTORTION
This is a monaural distortion effect that distorts the input signal. An EQ for shaping the
tone is connected in series.
Parameter
Depth
EQ frequency
EQ Gain
EQ Q
Wet/Dry
Effect
ENHANCER
This is a monaural effect that adds new overtones to the signal, making the sound more
crisp.
Parameter
Drive
Tune
Damp
Harmonics
Wet/Dry
Effect
EXPANDER
This is a monaural effect that expands the dynamic range by compressing the signal when
it falls below a specified level (threshold). This is the opposite effect from a compressor.
Parameter
Threshold
Ratio
Output
Attack
Release
Hold
Wet/Dry
Effect
FLANGER>MONO
This is a conventional flanger effect. The effect itself is mono-in/mono-out, but you can
adjust the panning of the effect sound if you are playing back in stereo.
Parameter
Rate
Depth
FB Invert
Feedback
Pan
Wet/Dry
Effect
144
Range
0–31 Adjusts the amount of distortion.
0–127 Adjusts the center frequency of the EQ.
–15dB–+15dB Adjusts the gain of the EQ.
0.5–10 Adjusts the Q of the EQ.
Adjusts the balance of the effect sound and dry sound. (With a
100/0–0/100
setting of 100/0, only the effect sound is output.)
ON/OFF Switches the effect on/off.
Range
Adjusts the gain of the signal that is input to the harmonic gen-
0dB–30dB
erator.
0–127 Adjusts the cutoff frequency of the filter.
0–127 Adjusts the filter decay curve (slope).
0–127 Adjusts the signal level of the boosted harmonics.
Adjusts the balance of the effect sound and dry sound. (With a
100/0–0/100
setting of 100/0, only the effect sound is output.)
ON/OFF Switches the effect on/off.
Range
–60dB–0dB Adjusts the threshold of the expander.
2:1–100:1 Adjusts the compression ratio of the signal below the threshold.
–20dB–+20dB Adjusts the output level of the effect sound.
0–127 Adjusts the attack of the effect.
0–127 Adjusts the release of the effect.
0–127 Adjusts the hold time of the effect.
Adjusts the balance of the effect sound and dry sound. (With a
100/0–0/100
setting of 100/0, only the effect sound is output.)
ON/OFF Switches the effect on/off.
Range
0.1Hz–10.0Hz Adjusts the LFO speed.
0–127 Adjusts the LFO depth.
ON/OFF Inverts (ON) the phase of the feedback signal.
0–127 Adjusts the amount of feedback.
L63–MID–R63 Adjusts the panning of the effect sound.
Adjusts the balance of the effect sound and dry sound. (With a
100/0–0/100
setting of 100/0, only the effect sound is output.)
ON/OFF Switches the effect on/off.
Function
Function
Function
Function