Akai MPC 4000 Reference Manual page 150

CHORUS+DELAY
This is a monaural composite effect that connects chorus and delay in series.
Parameter Range
Rate
0.1Hz–10.0Hz
Depth
0–127
Feedback
0–127
Delay
1ms–1500ms
Feedback
0–127
Bounce
ON/OFF
Wet/Dry 100/0–0/100
Effect ON/OFF
COMPRESSOR/LIMITER
This monaural effect compresses the dynamic range by restraining the level of signals
that exceed a specified level (the threshold). It also provides a noise gate that can be used
to eliminate noise heard while an instrument is not being played.
Parameter Range
Threshold
–60dB–0dB
Ratio
1:2–1:100
Output
–20dB–+20dB
Attack
0–127
Release
0–127
Threshold
–60dB–0dB
Release
0–127
Detect
PEAK/RMS
Wet/Dry
100/0–0/100
Effect
ON/OFF
DELAY>MONO
This is a conventional delay effect. The effect itself is mono-in/mono-out, but you can
adjust the panning of the effect sound if you are using stereo playback.
Parameter Range
Delay
1ms–1500ms
Feedback
0–127
HFdamp
20Hz–20kHz
Pan
L63–MID–R63
Wet/Dry 100/0–0/100
Effect ON/OFF
Function
Adjusts the LFO speed of the chorus effect.
Adjusts the LFO depth of the chorus effect
Adjusts the amount of feedback for the chorus effect.
Adjusts the delay time of the delay effect.
Adjusts the amount of feedback for the delay effect.
If this is ON, the delay sound will be panned alternately to left
and right for stereo playback.
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Switches the effect on/off.
Function
Adjusts the threshold of the compressor/limiter.
Adjusts the compression ratio for the signal that exceeds the
threshold.
Adjusts the output level of the effect sound.
Adjusts the attack of the effect.
Adjusts the release of the effect.
Adjusts the level at which the noise gate will open.
Adjusts the release time of the noise gate.
Selects whether the compressor/limiter will operate according
to changes in the peak level of the signal (PEAK), or according
to changes in the averaged level (RMS).
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Switches the effect on/off.
Function
Adjusts the delay time.
Adjusts the amount of delay feedback.
Adjusts the frequency at which the high-frequency range of the
feedback sound will be cut.
Adjusts the panning of the effect sound.
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Switches the effect on/off.
Edit page
141