Akai MPC 4000 Reference Manual page 21

Hint: The time signature is specified independently for each measure.
A "–" symbol will be displayed below the time signature field of measures that you modified. By holding
down the [SHIFT] key and pressing the CURSOR [ ® ] key, you can select multiple measures, and
change the time signature of the selected measures in a single operation.
7. Make settings as desired for the other fields of the Sequence block.
8. Move the cursor to the Trk field, and turn the [JOG] dial to select the track that
you want to record.
9. Move the cursor to the Out1 field, and turn the [JOG] dial to select the output
destination for the track.
10. Perform the following steps according to the output destination you selected.
If you selected PART
Use the Part field to select the part number, and use the program field to select the pro-
gram that you want to play.
When you select a program, the Program List popup window will appear.
A Program field
Displays the programs in the memory of the MPC4000. The cursor indicates the program
you have selected.
B Type field
Indicates the type of the program.
C Prog. field
Indicates the program change number assigned to that program.
D [F1] key (CANCEL)
Cancels the operation and closes the popup window.
E [F6] key (SELECT)
Finalizes the program selection.
If you selected OUT-A–OUT-D
Use the Ch field to select the output destination MIDI channel.
If you selected INT-A/INT-B
Use the CH field to select the output destination MIDI channel.
11. Strike the pads to verify that you can play the desired program or MIDI sound
module.
12. Move the cursor to the TC field, and turn the [JOG] dial to select the note value
that will be the minimum timing interval recorded in the track.
Hint: While you are pressing the [TIMING CORRECT] key, the cursor will temporarily move to the
TC field regardless of the current cursor location. You can hold down this key and turn the [JOG] dial
to adjust the setting.
1 2
4
Main page
3
5
11