Control Panel Operation; To Turn Your Heater On; To Turn Your Heater Off; Interruption To Electricity Or Gas Supply During Operation - Rinnai 650 Operation & Installation Manual

TO TURN YOUR HEATER ON

BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.
When the heater is in the OFF condition (the power supply connected and switched ON but the
NOTE
heater turned OFF) the Red Power Indicator
Access the 'Push Button Control Panel'
located on the front of the heater at the lower right
hand corner.
Step 1. Press ON / OFF button
be able to hear the ignition sparking.
Step 2. The sparking ignition stops when the pilot
flame has been established. The main
burner then ignites off the pilot flame and is
automatically preset to Stage 5 - High
Flame.
Flame Height & Fan Speed
The relationship between the
flame height and fan speed
NOTE
are preset and can not be
independently adjusted.
FLAME
1
HEIGHT
FAN
LOW LOW LOW HIGH HIGH
SPEED

TO TURN YOUR HEATER OFF

To turn the heater 'OFF' press the 'ON'/'OFF' button
once, the Red Power Indicator
a

INTERRUPTION TO ELECTRICITY OR GAS SUPPLY DURING OPERATION

Interruption to the power or gas supply will turn your heater off and a restart will be required. This is a safety feature
designed to ensure that un-attended starts do not occur after power or gas interuptions.

RESTART PROCEDURE AFTER INTERRUPTION TO ELECTRICITY SUPPLY

To restart your heater once power has been restored follow the steps for "TO TURN YOUR HEATER ON" as
above.

FULL CONTROL AND PARTIAL CONTROL

Full operation of the heater is only possible by using the remote control. In the event of a misplaced or broken
remote control or if the batteries for the remote control are flat, this appliance may still be operated in a limited
capacity by using the power ON/OFF button
corner of the appliance outer frame.
The heater will automatically modulate between flame settings to maintain the default set temperature of 22°C.
No additional control of the flame or heat output is possible via the appliance ON/OFF button.
Rinnai

CONTROL PANEL OPERATION

. This is
1
once. You will
a
2 3 4 5
will be extinguished.
b
of the 'Push Button Control Panel'
a
will be extinguished. This is normal.
b
12
1 b a
located at the lower right
1
RDV 600_700 OIM