Rinnai 650 Operation & Installation Manual page 37

Step 5. Charcoal Bed Installation
The charcoal bed is placed directly onto the burner
For the RDV700 you will need use both bags of the black
burner granules , while for the RDV600 approximately
F
only one and three quarter bags worth.
The brown burner fibre
approximately ten cent piece sized tufts.
To produce the best flame effect results, in a random
manner carefully place the black burner granules
the brown burner fibre tufts
surface of the burner
Allowing the burner media to sit over and around the
burner ports, will ensure that the flames from the gas jets
are diffused, which reduces any 'candling' effect of the
flame while also enhancing the realistic log burning look
of the heater.
DO NOT force any granular or fibrous
materials into
IMPORTANT
completely block any of the burner ports.
Keep the flame probe
contact with any of the burner media.
Step 6. FRONT log Installation
Identify the "FRONT" log and then carefully remove it
from the protective packaging.
Locate the two slots in the base of the log and carefully
place these over the positioning pins
the stone guard , ensuring that the detailed surface of
C
the log is facing out to the front.
Step 7. LEFT, MIDDLE & RIGHT log Installation
Identify the "LEFT" log and then carefully remove it from
the protective packaging.
Locate the two slots in the base of this log, noting that the
long slot is the rear most slot, and carefully place these
slots over the set of two left outermost positioning pins
located on both the "FRONT" and "REAR" logs.
Identify the "MIDDLE" log and then carefully remove it
from the protective packaging.
Locate the two slots in the base of this log, noting that the
long slot is the rear most slot, and carefully place these
slots over the set of two central positioning pins located
on both the "FRONT" and "REAR" logs.
Finally carefully remove the "RIGHT" log from the
protective packaging.
Locate the two slots in the base of this log, noting that the
long slot is the rear most slot, and carefully place these
slots over the set of two right outermost positioning pins
located on both the "FRONT" and "REAR" logs.
Step 8. Replacing the Burner Box Glass
Replace burner box glass panel assembly in the reverse
sequence to that explained in Step 1. on page 36.
Rinnai
BURNER MEDIA INSTALLATION
will need to be pinched into
H
loosely across the entire
H
.
I
the burner ports
free of any direct
J
which are part of
K
5
.
I
and
F
COVERING PORTS
or
6
7
8
37
F H
I
J
F
H
FRONT log
K
LEFT log
MIDDLE log
RIGHT log
REAR log
FRONT log
A
V 600_700 OIM
RD