Table of Contents
Advertisement
Failure to comply with these instructions could result in a fire or explosion which could
cause serious injury, death or property damage.
NOTE
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, personal injury or loss of life. Such work must only be performed by
an Authorised person.
When using the Constellation Flame Fire for the first time or after long periods of non
use, ignition may not occur the first time due to air in the gas pipes. If ignition does not
NOTE
occur after approximately 30 seconds the unit will cease operation automatically. Try
operating the unit again if this occurs.
The Constellation Flame Fire may make noises after ignition or extinction. This is due
to expansion and contraction of the internal components and is normal.
The Constellation Flame Fire will not ignite if the 'ON/OFF'
straight after extinction. After approximately 20 seconds has passed the unit will
automatically go into ignition mode.
OPERATION USING THE CONTROL PANEL
The control panel is located on the bottom right hand
side of the front panel of the Constellation Flame Fire.
TURNING THE CONSTELLATION 'ON'
Press and release the 'ON/OFF'
sequence will commence and the Power indicator
will illuminate. The pilot burner will ignite first, followed by the
main burner.
TURNING THE CONSTELLATION 'OFF'
Press and release the 'ON/OFF'
LED will go out.
ADJUSTING THE FLAME
Two flame settings are available, Low and High.
Pressing the 'Flame Up'
decrease the flame.
ADJUSTING THE FAN
Three fan settings are available, Off, Low and High. The fan operates independently from flame
adjustment.
Pressing the 'Fan Up'
on the control panel will illuminate.
Pressing the 'Fan Down'
5
LED on the control panel will illuminate.
Pressing the 'Fan Down'
LED on the control panel will go out.
OPERATION USING THE REMOTE CONTROL
The remote control emits an Infra Red (IR) signal and must be aimed at the receive unit located on
the control panel on the bottom right hand side of the front panel
approximately 5 metres, up to an angle of approximately 40 degrees to the horizontal. This range
may vary depending on the installation and the strength of the remote control batteries.
USING THE TIMER
Pressing the 'Timer'
4
LED will flash and the appliance will now operate for 30 minutes after which it will switch 'off'
automatically. Pressing the 'timer'
timer and the Power indicator
functions are available.
Rinnai Australia
OPERATION
1
button. The ignition
1
button. This will extinguish all flames and the Power indicator
button will increase the flame. Pressing the 'Flame Down'
8
button will operate the fan at 'High' speed. The 'Fan Hi' indicator
6
button once will operate the fan at 'Low' speed. The 'Fan Low' indicator
7
button a second time will switch the fan off. The 'Fan Low' indicator
7
button on the remote control will activate the timer. The Power indicator
4
button again within the 30 minute period this will cancel the
LED will stop flashing. Whilst operating in timer mode all other
2
8
+
-
LED
2
9
. The normal operating range is
3
- 9 -
button is pressed
1
6
3
2
+
4
-
5
7
1
2
button will
9
4
LED
5
2
Constellation 800/1000 Operation Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
