Table of Contents
Advertisement
TO TURN ON YOUR HEATER
BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.
You MUST read and understand these instructions fully before operating the heater.
NOTE
Locate the Standby / ON button
frame, IR receiver window
A
1.
Press the Standby / ON button
to purge the sealed combustion chamber before the gas flows.
2.
The green indicator located in the IR receiver window
You may also be able to hear the ignition sparking.
3.
When the green indicator located in the IR receiver window
established.
4.
The main burner then ignites off the pilot flame and is automatically pre-set to Stage 5 - High Flame. The
green indicator located in the IR receiver window
FLAME HEIGHT AND FAN SPEED
When operating the appliance via the Standby / ON button ONLY, no additional control of the
NOTE
flame or heat output is possible. The relationship between flame height and fan speed is factory
pre-set and cannot be adjusted. The heater will automatically modulate between flame settings to
maintain the default set temperature of 22°C.
To adjust flame or heat output, refer to "Remote Control Operation" on page 10 or to the Wi-Fi
user guide for these and other operational control options.
TO TURN OFF YOUR HEATER
To turn the heater 'OFF' press the Standby / ON button
Indicator will be extinguished.
INTERRUPTION TO ELECTRICITY OR GAS SUPPLY DURING OPERATION
Interruption to the power or gas supply will turn your heater OFF, upon resumption of the services the appliance will
need to be restarted. This is a safety feature designed to ensure that un-attended starts do not occur after power
or gas interruptions.
RESTART PROCEDURE AFTER INTERRUPTION TO ELECTRICITY SUPPLY
To restart your heater once power has been restored follow the steps for "To Turn ON Your Heater" as above.
FULL CONTROL AND PARTIAL CONTROL
Full operational control of the heater is only possible by use of the Wi-Fi App or to a lesser extent via the remote
control. In the event that either method of remote operation is not available, this appliance may still be operated in
a limited capacity by using the power Standby / ON button
Rinnai
CONTROL PANEL OPERATION
. This button is located on lower left inside edge of the appliances burner box
A
is also located near by.
B
B
Model RHFE800 shown for reference
once. The combustion fan will start several seconds before the fire ignites,
A
will flash to indicate that the pilot flame is lighting.
B
glows steady the pilot flame has been
B
will go out.
B
once, when the heater is in the off state the Red Power
A
as described in the note above.
A
9
Control & indicator locations
(Note that unlike other
design features, the controls
and indicators are ONLY
located on the one side of
double sided models).
RHFE0800_1000_1500 OM
Advertisement
Table of Contents
