Page 2
Important: Appliance must be installed with a Rinnai approved flue system. This appliance shall be installed in accordance with: - Manufacturer’s installation instructions - AS/NZS 5601.1 - Local regulations and municipal building codes Installation, servicing and repair shall be carried out only by authorised personnel.
Noise level Inside appliance, upper right hand side 33-41 dB(A) (beside convection fan). * Will vary according to gas type and flue configuration ** Will vary depending on geographical location in NZ 4 | Arriva 750 Installation Guide: 10473-C 03-13...
For every 25 mm of added mantel depth, there must be an additional 25 mm of vertical clearance. For example a mantel depth of 100 mm requires a vertical clearance of 150 mm. Arriva surround clearances Arriva 750 Installation Guide: 10473-C 03-13 | 5...
Location The main points governing location are flueing and warm air distribution. The Rinnai Arriva has a cool outer casing, it can be installed into an existing masonry, or decorative fireplace. Enclosure dimensions The heater must be positioned on a flat level surface that allows free movement of the appliance.
Flue terminal can be 5.5 m. The flue transition for all The Arriva must not be flued into natural flueing installations, excluding direct draft cavities. horizontal flueing, is counted a 90° bend. 8 | Arriva 750 Installation Guide: 10473-C 03-13...
Supporting the flue is usually completed during the framing stage with flue supports or straps within the cavity. Arriva 750 Installation Guide: 10473-C 03-13 | 9...
This kit also contains a • O-ring for ESPIPE (4350) sub-kit called the condensate drain • Spacer for ESPIPE (4351) kit (shown in next panel), and the flue slide stopper (part 4822). 10 | Arriva 750 Installation Guide: 10473-C 03-13...
Flue Outlet horizontal offset flue, the flue transition is fastened to the rear of the wall by standoff brackets supplied. Appliance needs to be down Down and out flue transition rated—refer data plate. 12 | Arriva 750 Installation Guide: 10473-C 03-13...
(supplied in the plastic bag with the remote control), or the flue slide stopper (provided with the ASPDFK Appliance mounting and ASPKIT03 flue kits). The points clamping component will 5: Secure heater Arriva 750 Installation Guide: 10473-C 03-13 | 13...
Place the right hand bottom log on the opposite side. Replace the combustion 6. Placing the right hand bottom log chamber glass panel and secure in place with the two retaining screws. 14 | Arriva 750 Installation Guide: 10473-C 03-13...
Do not attempt to adjust the air flow direction while the appliance is operating or still hot as this could result in a burn injury. Arriva 750 Installation Guide: 10473-C 03-13 | 15...
Installing the front panel screws, through the front of the warm air discharge louvre. Installing the top panel Push the top panel down into place and secure with the screws provided. Installing the top panel 16 | Arriva 750 Installation Guide: 10473-C 03-13...
Complete the installation checklist in the customer operation guide, and make sure you leave the guide with the customer. Explain to the customer about the use and care of the unit, and ensure they understand the instructions and operation of the appliance. 18 | Arriva 750 Installation Guide: 10473-C 03-13...