Features; Control Panel Operation - Rinnai RF800 Operation & Installation Manual

FEATURES

Reflectors
Air Intake

CONTROL PANEL OPERATION

To operate your appliance for the first time, ensure that the gas supply
is on and that the appliance has been tested and commissioned by
an authorised installer.
Switch on the power supply to the appliance (This is usually a wall
switch near to the appliance).
The appliance can now be started by using either the Control Panel
or the Remote Control.
Ignition
Start the appliance by pressing the ON/OFF button for at least one
second until the red light on the control panel comes on.
If the appliance has not been used for some time then the gas may take some time to ignite as the
gas in the pipes may need to purge.
NOTE
The appliance will try to start for up to one minute before "locking out". If this happens, then
press the ON/OFF button twice to re-set then re-start the appliance.
If the appliance has not started after 3 attempts, contact the installer or an authorised service
person.
Always run the appliance on high for at least a few minutes to ensure a quick warming up of the firebox and flue.
The appliance will start on the same flame setting it was last used at unless the mains power
supply has been disrupted or disconnected, whereby the default flame setting is reset to low.
NOTE
To ensure a high setting, during ignition press the flame control + button for up to 10 seconds
(refer to the remote control operation on page 6 for flame control details).
Once the Pilot has ignited, then gas will begin to flow to the main burner. The flame picture should be right across
the burner within about 10 seconds.
If the burner does not light or only lights part way across then turn the appliance off immediately and call an
authorised service technician for further advice.
Turning Off
The appliance can be stopped by pressing the ON/OFF button on the Control Panel or by pressing the power
button on the remote control (refer to the remote control operation on page 6 for details).
The flames may take a few seconds to fully extinguish. This is normal and is not a cause for concern.
Rinnai 5
Hot Air
Outlet Louvre
Outer Trim
Burner Media
(Logs, Coals/
Pebbles/ Glass)
Front Panel
Control Panel
ON/OFF Button
Operation LED
Remote Receiver Window
RF800 OIM