Attaching Fascia Assembly - Rinnai 650 Operation & Installation Manual

COMPLETING HEATER INSTALLATION

ATTACHING FASCIA ASSEMBLY

Step 12. Attach the Fascia to the Heater Engine
E
The fascia is mounted to the engine via three (
body each of which contains a factory pre-positioned 8g (10mm) screw
,
These screws have been pre-inserted by the manufacturer to ensure correct threading of the
fascia securing points.
NOTE
Carefully pick up fascia assembly and position it in front of the heater engine, connect the RJ45 plug
socket located on the back of fascia on the bottom left hand corner, (this connects the push button control panel
D
via a communications cable to the heater engine's control box).
Guide the tabs into the fascia assembly mounting slots
E
assembly until it is flush at all the edges.
Ensure you DO NOT place excessive tension on or pinch the communication cable
manoeuvring the fascia into position.
NOTE
Re-fit and tighten the three fascia retaining screws
within the heater engine body.
The glass of the fascia fitted to this appliance reduces the risk of fire and injury and no part of it
should be permanently removed.
NOTE
For protection of young children or the infirm a secondary guard is required.
If the heater is not operating correctly refer to the "TROUBLE SHOOTING CHECKLIST" on page 17
before contacting Rinnai.
WARNING
It is the responsibility of the installer to check that under normal operating conditions of the
appliance, all flue gases are exhausted to the outside atmosphere and that there is no spillage of
combustion gases into the room. Please refer to AS/NZS 5601.
During the initial burning in period of approximately 2 hours, some minor smoke and smell may
be experienced. During this period the heater should be operated on High and the space being
heated should be well ventilated. It may take up to 20 minutes of operation for the logs to achieve
their full flame pattern and glow.
Burner aerations are factory set and can NOT be adjusted. If you are unable to get the unit to
operate correctly refer to "TROUBLE SHOOTING CHECKLIST" on page 17 before contacting
Rinnai.
Rinnai
E
A
F
i
D
i
B
B
A
iii
F
B
C
ii
, mounting points
& )
i ii iii
and gently push the lower edge of the fascia
F
through the fascia and into the fascia mounting points
B
43
ii
A
iii
A
B
within the heater engine
located
A
, remove and retain
all three screws
B
A
B
A
B
.
into the
C
when
C
A
RDV 600_700 OIM