Control Panel Operation; To Turn Your Heater On; To Turn Your Heater Off; Interruption To Electricity Or Gas Supply During Operation - Rinnai RIB2312L Operation & Installation Manual

TO TURN YOUR HEATER ON

BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.
When the heater is in the OFF condition (the power supply connected and switched ON but the
NOTE
heater turned OFF) the Red Power Indicator
Access the 'Push Button Control Panel'
on the top left hand side of the appliance.
Step 1. Press the ON / OFF button
able to hear the ignition sparking.
Step 2. The sparking ignition stops when the pilot flame
has been established.
The main burner then ignites off the pilot flame and
is automatically preset to Stage 5 - High Flame.
FLAME HEIGHT AND FAN SPEED
The relationship between flame height and fan
NOTE
speed is factory preset and cannot be adjusted.
Refer to "REMOTE CONTROL OPERATION" on
the next page for Flame / Fan options.
Flame Height
Fan Speed
(2 speed only)

TO TURN YOUR HEATER OFF

To turn the heater 'OFF' press the 'ON'/'OFF' button
once, when the heater is in the off state the Red Power
Indicator will be extinguished.
b

INTERRUPTION TO ELECTRICITY OR GAS SUPPLY DURING OPERATION

Interruption to the power or gas supply will turn your heater off and a restart will be required. This is a safety feature
designed to ensure that un-attended starts do not occur after power or gas interruptions.

RESTART PROCEDURE AFTER INTERRUPTION TO ELECTRICITY SUPPLY

To restart your heater once power has been restored follow the steps for "TO TURN YOUR HEATER ON" as
above.

FULL CONTROL AND PARTIAL CONTROL

Full operation of the heater is only possible by using the remote control. In the event of a misplaced or broken
remote control or if the batteries for the remote control are flat, this appliance may still be operated in a limited
capacity by using the power ON/OFF button
side of the appliance.
The heater will automatically modulate between flame settings to maintain the default set temperature of 22°C.
No control of the flame or heat output is possible via the appliance ON/OFF button.
NOTE
Rinnai

CONTROL PANEL OPERATION

. This is located
1
once. You will be
a
1 2 3
Low Low Low High High
of the 'Push Button Control Panel'
a
will be extinguished. This is normal.
b
1
1
4 5
a
12
a
b
1
located on the top left hand
1
SAPPHIRE RIB2312 OIM